#6501 is a reflective film to be applied onto the fabric
with thermo and pressure. It is an open lens type reflective
film, consisting of high index reflective micro glass
beads, reflective layer and adhesive layer.
It is an epoch-making product and is designed to reflect
more than 90% of entered light by means of a unique reflective
layer.
It greatly enhances the night-time visibility of a wearer
so it is very useful to prevent traffic accident. Its
day-time appearance is bright grey, and it has very high
reflectivity in silver white color at night.
 |
BS
EN471 Test report No. BTX09085(2)/MIP/96 by SGS U.K
▶
Configulation : Microscopic glass beads
▶
Size
: 1meter X 100meter/roll
▶ Use : High visibility
garment, Leisure & Activity Clothing
▶ Performance :
550~630Cd/Lux.㎡(E/A:-4°
O/A: 0.2°)
▶Type : Glass beads
heat transfer film
TEST SPECIFICATION OF BS EN471
BS EN471:1994 Specification for High Visibility Clothing-
Class 2 materials
Clause 6.1 Retro-reflective performance requirements
of new materials; and clause 6.2 Retro-reflective performance
requirements after test exposures to abrasion, flexing,
folding at cold temperatures, temperature variation,
washing(50 cycle, drycleaning(25 cycle), and influence
of rainfall.
REFLECTIVE PERFORMANCE(BS
EN471) OF #6301 & #6501
#6501 fully meets and exceeds the requirements of
BS EN471(Table 5, Class 2) and is thus suitable for
Personal Protective Equipments(PPE) garments.
|
Entrance Angle/ Observation Angle |
Typical |
Minimum |
EN471 |
|
5°/12'(0.2)
|
580 |
550 |
330 |
|
5°20'(0.33°) |
420 |
380 |
250 |
Tested
in accordance with EN471
※Entrance Angle(5°) is the angle
between the light source and a line perpendicular to
the reflective film. Observation Angle(12'/20') is the
angle at which the light is reflected back from the
reflective film to a observer.
|
 |
APPLICATION INSTRUCTIONS
1.Draw the letters or marks on the protective
paper and cut them with the scissor or cutter.
2.Remove the protective film from the back(then,
dry adhesive appears).
3.Place the reflective film on the fabric
products, such as garments and bags, and then cover
the fabric with a cloth and press it firmly with hot
iron at 130℃ for 10seconds.(take care to keep the
dry adhesive side to contact the fabric)
4.Remove the protective film from the fabric after
making sure the fabric after making sure the fabric
is completely cooled down. Do not remove the protective
film when the fabric is still warm.
5.Users should test beforehand if the sufficient
adhesion is obtained and also the fabric may not
be damaged by heating.
|
|
